QNAP QMiro-201W User Manual

Setting User Action
Security Select one of the following security authentication methods:
• WPA2-PSK
• WPA-PSK+WPA2-PSK
• WPA-Enterprise
• WPA2-Enterprise
Note
Enter a Remote Authentication Dial-In User Service
(RADIUS) server IP address and server port number if
the security authentication method is set to WPA-
Enterprise or WPA2-Enterprise.
Password Specify a password that contains 8 to 63 characters.
Note
The password is case-sensitive.
Guest wireless IP address Specify a fixed IP address for the guest wireless network.
Subnet mask Specify the subnet mask used to subdivide your IP address
4. Configure the guest wireless DHCP server settings.
Setting User Action
Start IP address Specify the starting IP address in a range allocated to DHCP clients.
End IP address Specify the ending IP addresses in a range allocated to DHCP clients.
DNS server 1 Specify a DNS server for the DHCP server.
DNS server 2 Specify a secondary DNS server for the DHCP server.
Important
QNAP recommends specifying at least one DNS
server to allow URL lookups.
5. Click Apply.
QuRouter saves the guest wireless network settings.
Configuring Wi-Fi Protected Setup (WPS)
1. Go to Wireless > WPS .
2.
Click .
The WPS function is enabled.
3. Configure the WPS settings.
a. Select the WPS SSID from the drop-down menu.
b. Click WPS.
QMiro-201W User Guide
Network Settings 36

QNAP QMiro-201W Specifications

General

Brand	QNAP
Model	QMiro-201W
Category	Wireless Router
Language	English