QNAP TS-219P User Manual

8. R
otate the memory module towards the motherboard until the securing clips clicks
into place.
9. Close the case cover and fasten the screws. Connect the power adaptor and cables
back to the NAS.
10. To check that the memory module is recognized by the NAS, power up the NAS and
login the web interface as an administrator. Go to "System Status" > "System
Information" and check the total memory in "Hardware Information".
26

QNAP TS-219P Specifications

General

Processor family	Marvell
Processor frequency	1.2 GHz
Number of processors installed	1
Storage drive size	3.5 \
Storage drive capacity	0 GB
Storage drive interface	Serial ATA II
Total installed storage capacity	0 TB
Number of storage drives installed	0
Number of storage drives supported	2
Flash memory	16 MB
Internal memory	0.5 GB
eSATA	Yes
USB 2.0 ports quantity	3
Dimensions (WxDxH)	102 x 216 x 150 mm
Power requirements	100 - 240 V AC, 50 - 60 Hz
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Chassis type	Tower
Power supply unit (PSU) capacity	60 W

Weight and Dimensions

Weight	1740 g