QNAP TS-219P User Manual

Warning: The NAS supports replacing the redundant power supply unit without
turning off the server when redundant power supply mode is enabled. However, users are
strongly recommended to turn OFF the NAS before replacing the power supply unit to
reduce the risk of electric shock.
A second power supply unit can be installed on a single power (SP) rackmount NAS model
to upgrade the SP model to redundant power (RP) model.
10.2 2U Turbo NAS (TS-1279U-RP and TS-EC1279U-RP only)
T
he following instructions should only be performed by an authorized and trained
technician.
To replace a failed power supply unit on the TS-1279U-RP or TS-EC1279U-RP Turbo NAS,
follow the steps below.
1. Turn off the NAS.
2. Hold the black handler and press and hold the green button firmly.
52

QNAP TS-219P Specifications

General

Processor family	Marvell
Processor frequency	1.2 GHz
Number of processors installed	1
Storage drive size	3.5 \
Storage drive capacity	0 GB
Storage drive interface	Serial ATA II
Total installed storage capacity	0 TB
Number of storage drives installed	0
Number of storage drives supported	2
Flash memory	16 MB
Internal memory	0.5 GB
eSATA	Yes
USB 2.0 ports quantity	3
Dimensions (WxDxH)	102 x 216 x 150 mm
Power requirements	100 - 240 V AC, 50 - 60 Hz
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Chassis type	Tower
Power supply unit (PSU) capacity	60 W

Weight and Dimensions

Weight	1740 g