EasyManuals Logo

QNAP TS-219P User Manual

QNAP TS-219P
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Regulat
ory Notice
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/television technician for help.
The changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Shielded interface cables, if any, must be used in order to comply with the emission limits.
CE NOTICE
Class B only.
4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QNAP TS-219P and is the answer not in the manual?

QNAP TS-219P Specifications

General IconGeneral
Processor familyMarvell
Processor frequency1.2 GHz
Number of processors installed1
Storage drive size3.5 \
Storage drive capacity0 GB
Storage drive interfaceSerial ATA II
Total installed storage capacity0 TB
Number of storage drives installed0
Number of storage drives supported2
Flash memory16 MB
Internal memory0.5 GB
eSATAYes
USB 2.0 ports quantity3
Dimensions (WxDxH)102 x 216 x 150 mm
Power requirements100 - 240 V AC, 50 - 60 Hz
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)0 - 95 %
Chassis typeTower
Power supply unit (PSU) capacity60 W
Weight and Dimensions IconWeight and Dimensions
Weight1740 g

Related product manuals