QNAP TS-219P User Manual

Syst
em Messages
When the NAS encounters system error, an error message will be shown on the LCD panel.
Press the “Enter” button to view the message. Press the “Enter” button again to view the
next message.
S y s t e m E r r o r !
P l s . C h e c k L o g s
System Message Description
Sys. Fan Failed The system fan fails
Sys. Overheat The system overheats
HDD Overheat The hard drive overheats
CPU Overheat The CPU overheats
Network Lost Both LAN 1 and LAN 2 are disconnected in failover or
load-balancing mode
LAN1 Lost LAN 1 is disconnected
LAN2 Lost LAN 2 is disconnected
HDD Failure The hard drive fails
Vol1 Full The volume is full
HDD Ejected The hard drive is ejected
Vol1 Degraded The volume is in degraded mode
Vol1 Unmounted The volume is unmounted
Vol1 Nonactivate The volume is not activated
49

QNAP TS-219P Specifications

General

Processor family	Marvell
Processor frequency	1.2 GHz
Number of processors installed	1
Storage drive size	3.5 \
Storage drive capacity	0 GB
Storage drive interface	Serial ATA II
Total installed storage capacity	0 TB
Number of storage drives installed	0
Number of storage drives supported	2
Flash memory	16 MB
Internal memory	0.5 GB
eSATA	Yes
USB 2.0 ports quantity	3
Dimensions (WxDxH)	102 x 216 x 150 mm
Power requirements	100 - 240 V AC, 50 - 60 Hz
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Chassis type	Tower
Power supply unit (PSU) capacity	60 W

Weight and Dimensions

Weight	1740 g