The TS-451DeU supports connecting a maximum of two USB expansion units. You can use any of the
following configurations:
Expansion Unit Type Number of Units Supported
TR-004 2
TL-R1200C-RP 1
1. Connect the expansion unit to the NAS.
a. Connect the USB cable to the USB Type-C port on the expansion unit.
b. Connect the USB cable to a USB 3.2 Gen 1 Type-A port on the NAS.
2. Power on the expansion units.
3. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Installing Handles
Installing handles enables you to better grip and secure the NAS.
1. Power off the NAS.
2. Install a handle on an angle bracket.
a. Align the openings on the handle with the two round screw holes on the angle bracket.
b. Attach the screws to lock the handle to the angle bracket.
TS-451DeU User Guide
Installation and Configuration 26
To Next Page
Loading...
Need help?
General
