To Next Page

To Previous Page

Reason 4 Bad SCSI cabling. It is recommended that you always use high-

quality “premium” SCSI cables to eliminate data corruption, parity

errors and other problems. “Premium” can be defined as double-

shielded, layered twisted pair with 25 wire pairs, single-ended

impedance of 80-110 ohms, and molded.

Step 1: Turn off the power to your PC and all peripherals.

Step 2: If possible, verify that all SCSI external cables are “premium” and

remove all non-premium external SCSI cables.

Step 3: If you are unsure of the quality of the cables you are using, disconnect

all cables and peripherals from your system. Use the supplied cable

to attach the CD-R Drive and power on all peripherals and then your PC.

Step 4: If everything boots up fine, power off the PC and all peripherals,

and begin attaching another cable and peripheral to your system.

Step 5: Repeat Step 4 until you have a problem. When a problem exists,

try using a different SCSI cable and repeat Steps 4 and 5 until you

can rule out all possible bad cables by the process of elimination.

Questions

Other manuals for QPS Que! Drive

Questions and Answers:

Need help?

Do you have a question about the QPS Que! Drive and is the answer not in the manual?

General