EN
15 (DRAFT 2017/05/02)
TD-000523-00-01-C
PRESETS Select a pre-programmed EQ and dynamic processing setting for specific applications
Factory
Presets
Example
BASS AMP
HAND MIC
FACTORY PRESETS
AC GUIT/VOX
Use the Selector knob to scroll (up or down) to the Preset you wish to recall.
DEFAULT The basic voicing of the loudspeaker
LIVE For live sound reinforcement and vocal clarity
LIVE BRIGHT Similar to LIVE with some high-frequency boost to balance the sub
DANCE Low and high frequency emphasis
STAGE MONITOR 1 For stage monitor use when low frequency reproduction is needed
STAGE MONITOR 2 For most stage monitor uses, reduces excessive bass build-up on stage
AC GUIT / VOX For Acoustic Guitars and VOX
BASS AMP For direct connection of bass instruments
HAND MIC For speech intelligibility and feedback reduction using a hand-held microphone.
HEAD MIC For speech intelligibility and feedback reduction using a head microphone.
STUDIO MON For use as a recording monitor
SUB MENU Select a setting to match the top-box with a subwoofer
SUB Menu
Example
80 Hz KS
100 Hz K – KW – KLA
SUB MENU
NO SUB
In the example, the 80 Hz KS high-pass filter is selected. Use the Selector knob to
scroll to the filter you need, then press the Enter button.
NOTE: All crossovers share the same phase – the only time alignment to make is
compensating for the actual distance between sub and top boxes
NO SUB For use without a subwoofer
80 Hz KS Applies an 80 Hz High Pass Filter (HPF)
100 Hz K – KW – KLA Applies a 100 Hz High Pass Filter (HPF) (For use with a K-SUB, KW Sub, or KLA Sub)
125 Hz Applies a 125 Hz High Pass Filter (HPF)
DELAY Adjust the signal delay for rear fill and similar applications.
Delay
1.13
0.43
DELAY
1.00 ms
FEET
METERS
0 –100 milliseconds, 0 – 113 feet, 0 – 34 meters
All units of measure change together when the Selection knob is turned.
EQ Adjust the 4-band, parametric equalizer
EQ Example
EQ1
EQ2
EQ
HIGH
LOW
EQ IN
1.13
0.43
-2.0
1.13
1.13
0.43
8.00k
1.13
0.7
0.7
RESET
dB Hz Q
In the example, EQ1 is selected. Press the Enter button to adjust. When you are
finished, press the Enter button to make the change, or the Exit button to exit without
changing the parameter.
dB Hz Q
High Shelving Band
Default
0.0 dB to -6.0 dB
0.0 dB
1.0 kHz to 10.0 kHz
8.0 kHz
N/A
EQ1 (EQ for Band 1)
Default
0.0 dB to -6.0 dB
0.0 dB
50 Hz to 20.0 kHz
1.0 kHz
0.4 to 4.0
0.7
EQ2 (EQ for Band 2)
Default
0.0 dB to -6.0 dB
0.0 dB
200 Hz to 20 kHz
1.0 kHz
0.4 to 4.0
0.7
Low Shelving Band
Default
0.0 dB to -6.0 dB
0.0 dB
100 Hz to 500 Hz
100 Hz
N/A
EQ IN/OUT Engages / bypasses the equalizer
RESET Returns the EQ to the flat, default settings
To Next Page
Loading...
