2
Horizontal Suspension
(Figure 2)
When suspending the KW122 in a horizontal position you must install the Pull Back Bar
and two eyebolts in one of the side panels.
Tools Required:
6 mm Hex Wrench (Allen Wrench)
7 mm Open End / Box End Wrench
Parts Required:
Pull Back Bar, KW122 – (1)
M10 Eyebolt – (3)
KW122 Pull Back Gasket – (1)
M10 Nut – (1)
M10 Lock Washer – (2)
M10 Flat Washer – (2)
M10 Button Head, Hex Socket, Screw – (1)
Horizontal Suspension (Figure 2)
The Pull Back Bar attaches to the same M10 installation location, as shown, regardless of
which side the LF Driver is on.
NOTE: If you are suspending the KW122 in the direction opposite of what is shown:
The Pull Back Bar is installed in the same place as shown.
The Eyebolt is installed in the as shown in the alternate installation (Figure 3).
The two “top” Eyebolts are installed in the same positions, but on the other side of
the enclosure. (Figure 2).
1. Remove the factory installed M10 flat-head screw from the side of the enclosure to which
the Pull Back Bar is to be attached.
2. Test fit the Pull Back Bar, attachment, washers, and gaskets to ensure proper assembly prior
to sticking self-adhesive gasket to Pull Back Bar.
3. Attach the Pull Back Gasket to the Pull Back Bar by peeling off the adhesive backing and
pressing the adhesive side to one end of the Pull Back Bar. Ensure that the hole in the
gasket aligns with the hole in the Pull Back Bar.
4. Install one M10 Lock Washer, then one M10 Flat Washer, onto the M10 Hex Socket, Button-
head screw.
5. Insert the screw into the Pull Back Bar through the hole with the gasket, from the opposite
side of the Pull Back Bar from the gasket. (The gasket goes between the Pull Back Bar and
the loudspeaker enclosure.
6. Using a 6 mm hex wrench, bolt the Pull Back Bar to the enclosure with the screw and two
washers. Before tightening fully, ensure the Pull Back Bar is perpendicular to the edge of the
enclosure. Tighten the screw until the split lock washer is flattened.
7. Insert the eyebolt into the Pull Back Bar. The “eye” of the eyebolt must be oriented toward
the two “top” eyebolts installed in the enclosure. Attach the eyebolt to the Pull Back Bar
with hex nut, lock washer, and flat washer. Tighten until the split lock washer is flattened.
Install Two Top-surface Eyebolts (Figure 2)
1. Use a 6 mm hex wrench to remove the two factory-installed M10 flat-head screws from the side (top) of the loudspeaker enclosure. This side
becomes the top.
2. Thread one eyebolt into each of the two threaded inserts on the top side of the loudspeaker enclosure. Do not use washers.
3. Tighten the eyebolts until their shoulders are snug against the enclosure. Continue to rotate the eyebolts until they reach the desired position.
2
3
2
– Figure 2 –
– Figure 3 –
1
1
3
To Next Page
Loading...
