Install One Pull Back Eyebolt
1. Using a 6 mm hex wrench, remove the M10 flat head screw located at the rear of the enclosure, just below the amplifier module.
NOTE: You can optionally use the threaded insert just above the amplifier module for the pull back eyebolt.
2. Thread an eyebolt into the enclosure’s threaded insert; do not use a flat washer or standoff on the pull back eyebolt.
3. Tighten the eyebolt until the shoulder is snug against the enclosure. Continue to rotate the eyebolt until it reaches the desired position.
© 2023 QSC Audio Products, LLC. All rights reserved. QSC and the QSC logo are registered trademarks of
QSC Audio Products, LLC in the U.S. Patent and Trademark office and other countries. Tilt-Direct, DMT, Intrinsic
Correction, DEEP and GuardRail are all trademarks of QSC Audio Products, LLC. All other trademarks are the
property of their respective owners. Patents may apply or be pending.
TD-000318-00 B
Horizontal Suspension
Tools Required:
6 mm Hex Wrench (Allen Wrench)
Parts Required:
M10 Eyebolt – (3)
Install Two Top-surface Eyebolts (Figure 5)
1. Use a 6 mm hex wrench to remove the two factory-installed M10 flat-head screws from
the side (top) of the loudspeaker enclosure. This side becomes the top.
2. Thread one eyebolt into each of the two threaded inserts on the top side of the
loudspeaker enclosure. Do not use washers.
3. Tighten the eyebolts until their shoulders are snug against the enclosure. Continue to
rotate the eyebolts until they reach the desired position.
Install One Pull Back Eyebolt
1. Use a 6 mm hex wrench to remove the M10 flat head screw located at the rear of the
enclosure just above the amplifier module.
2. Thread an eyebolt into the threaded insert. Do not use washers.
3. Tighten the eyebolt until the shoulder is snug against the enclosure. Continue to rotate
the eyebolt until it reaches the desired position.
– Figure 5 –
3
2
1
KW152 and KW153 Loudspeaker Systems
The KW152 and KW153 can be suspended vertically with the LF Driver on the top or bottom. The following instructions apply to either orientation.
Vertical Suspension
Tools Required:
6 mm Hex Wrench (Allen Wrench)
Parts Required:
M10 Eyebolt – (3)
Install Two Top-surface Eyebolts (Figure 4)
1. Use a 6 mm hex wrench to remove the two factory-installed M10 flat-head screws from the
top of the loudspeaker enclosure.
2. Thread one eyebolt into each of the two threaded inserts on the top of the loudspeaker
enclosure. Do not use washers.
3. Tighten the eyebolts until their shoulders are snug against the enclosure. Continue to rotate
the eyebolts until they reach the desired position. back eyebolt.
1
2
3
– Figure 4 –
4
To Previous Page
Loading...
