EasyManua.ls Logo

QSC PLD Series - Page 18

QSC PLD Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 QSC Audio Products LLC
Application Engineering Team
Factory Preset Display Description
F13
Channels A and B
parallel for 4Ω sub-
woofer; channels C
and D separate full
range
This is similar to F2, with these additions:
Channels A and B are parallel, with a 48 dB/octave Butter-
worth low-pass filter at 80 Hz. The signal is summed from
inputs 1 and 2.
Channels C and D are separate, suitable for stereo mains, with
48 dB/octave Butterworth high-pass filters at 80 Hz, which
perfectly complements the subwoofer filtering in A and B.
Channel C’s signal is from input 1 and D’s is from input 2.
These parameters are only a starting point; you can alter any of
them and save the configuration into a user preset.
F14
Channels A and B
bridged, full range;
channels C and D
bridged, full range
This is similar to F6, with these additions:
Input 1 goes to the bridged channels A and B; Input 2 goes to
the bridged channels C and D.
These parameters are only a starting point; you can alter any of
them and save the configuration into a user preset.
F15
Single bi-amp
mode: Channels A
and B bridged for
4–8Ω LF; channels
C and D bridged
for 4–8Ω HF
This is similar to F6, with these additions:
Input 1 goes to the bridged channels A and B, with a 48 dB/
octave Butterworth low-pass filter at 1.5 kHz.
Input 2 goes to the bridged channels C and D, with a 48 dB/
octave Butterworth high-pass filter at 1.5 kHz.
These parameters are only a starting point; you can alter any of
them and save the configuration into a user preset.
F16
Single bi-amp
mode: Channels A
and B parallel for
2–4Ω LF; channels
C and D parallel for
2–4Ω HF
This is similar to F4, with these additions:
Channels A and B are parallel, with a 48 dB/octave Butter-
worth low-pass filter at 1.5 kHz. The signal source is Input 1.
Channels C and D are parallel, with a 48 dB/octave Butter-
worth high-pass filter at 1.5 kHz. The signal source is Input 2.
These parameters are only a starting point; you can alter any of
them and save the configuration into a user preset.

Other manuals for QSC PLD Series

Related product manuals