Need help?Do you have a question about the QSC PLX 1104 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Response | 20Hz - 20kHz (+0/-0.5dB) |
| Signal-to-Noise Ratio | > 100 dB |
| Weight | 15.9 lbs (7.2 kg) |
| 8 Ohm Bridged | 700 W |
| Signal to Noise Ratio | > 100 dB |
| Voltage Gain | 32 dB |
| Cooling | Fan cooled |
| Dimensions | 3.5 x 19 x 12.5 in |
| Input Sensitivity | 1.4 V |
| Damping Factor | >200 |
| Total Harmonic Distortion (THD) | <0.05% |
| THD | <0.05% |
| Input Impedance | 10k Ohms unbalanced, 20k Ohms balanced |
| Connectors | XLR, 1/4 in TRS |
| Total Harmonic Distortion | <0.05% |
Lists essential safety instructions for operating and maintaining the amplifier.
Explains the meaning of warning symbols used in the manual.
Highlights critical safety cautions and warnings regarding electric shock.
Details FCC compliance for Class B digital devices and interference mitigation.
Highlights key features of the PLX 1104 and PLX 1804 amplifier models.
Details additional features found in PLX 1802, 2502, 3102, and 3602 models.
Lists the items included in the amplifier's factory-packed carton.
Identifies and describes the front panel controls and LED indicators.
Details the various connectors and features on the amplifier's rear panel.
Provides instructions and recommendations for mounting the amplifier in a rack.
Explains the amplifier's cooling system and airflow direction.
Outlines the correct procedure for connecting the amplifier to AC power.
Presents typical current draw for each model under various load conditions.
Details how to use the input configuration switch for different operating modes.
Explains the purpose and operation of the clip limiter feature.
Describes the low frequency filter options and their selection for different speaker types.
Details the balanced XLR and TRS input connectors and their pinouts.
Explains how to parallel input signals to both channels on specific models.
Details Speakon connector wiring and usage for Stereo, Parallel, and Bridge modes.
Describes binding post connector usage for Stereo, Parallel, and Bridge modes.
Specifies minimum impedance limits and provides output terminal safety warnings.
Explains the function and indications of the Power, Clip, Signal, and -10 LEDs.
Details the Amber LEDs for Bridge (BR M) and Parallel (PAR) modes on relevant models.
Describes the function, adjustment range, and markings of the gain controls.
Details the operation of the power switch and initial LED behavior.
Details the protection systems for PLX 1802, 2502, 3102, and 3602 models.
Details the protection systems for PLX 1104 and PLX 1804 models.
Lists output power ratings and distortion specifications for PLX 1104/1804.
Details frequency response and signal-to-noise ratio for PLX 1104/1804.
Covers input sensitivity, impedance, dynamic headroom, damping factor, and protection.
Lists output power ratings and distortion specifications for PLX 1802-3602.
Details frequency response and signal-to-noise ratio for PLX 1802-3602.
Covers input sensitivity, impedance, dynamic headroom, damping factor, and protection.
Illustrates the two-wire, single-channel connection for Speakon loudspeakers.
Illustrates the four-wire, two-channel connection for Speakon loudspeakers.
Shows the correct Speakon wiring for bridge mode output connection.
Provides mailing address, telephone numbers, fax, and email for QSC.
To Next Page
