Edit Functions
Accessing User Chords
User chords are stored on the SD card. The bank will be filled with empty chords if no SD
card is inserted.
To access user chords, hold the Harm button for 3 seconds.
This will disable any auto-harmonization, and the Harm LED will illuminate white.
Quality will select from one of twelve user chords.
Pressing this button again will exit custom chord usage.
An SD Card is required for the storing/loading of custom chords between power cycles.
Creating User Chords
User chords can be created in two ways.
When a chord is saved the Maj/Min LEDS will blink to indicate whether the write was suc-
cessful or not.
The LEDs will blink Green if the write succeeded.
The LEDs will blink Red if the write failed.
If writing fails multiple times in a row, the SD card most likely needs to be reinitialized by
rebooting the module.
Creating User Chords on the SD Card
Custom chords can be edited on the SD Card
The chord is defined first by the prefix “CHORD_” Followed by a number 1-12
After that, a comma-separated list of semitone offsets can be used to specify the chord.
Since the root output will always be the root. Only the third, fifth, and seventh are specified.
Here are a few examples where CHORD_1 is Major, CHORD_2 is Minor, CHORD_3 is
Dominant, and CHORD_4 is a Tone Cluster.
CHORD_1=4,7,11
13
To Next Page
Loading...
Need help?
General