Qu-Bit Electronix Chord v2 User Manual

Default Value: 0
LEAD_OFFSET
This value is an offset in octaves for the lead input.
Value can be positive or negative.
Setting this to 1 will set the default lead input to 1 octave above the root output.
Setting this to -1 will set the default lead input to 1 octave below the root input.
Default Value: 0
Custom Chords
Custom chords are loaded/stored on the SD card as well.
See the dedicated section in the manual above for more information on preparing these.
Example
This example will:
• Disable autoharm quantization.
• Set the custom waveforms to be loaded as a single, large bank.
• Sets custom chord 1 to a major seven chord.
• Sets custom chord 2 to a minor seven chord.
• Sets custom chord 3 to a tone cluster close to the root.
QUANTIZE_AUTOHARM=0
LONGFORM_USERBANK=1
CHORD_1=4,7,11
CHORD_2=3,7,10
CHORD_3=0.2,0.4,0.6
User Wavetable Creation
User wavetables can be loaded from a single .wav file.
Each wavetable should be mono, 256 samples long, with 64 total waveforms. This makes
the entire .wav file 32kB.
16

Qu-Bit Electronix Chord v2 Specifications

General

Brand	Qu-Bit Electronix
Model	Chord v2
Category	Music Equipment
Language	English