EasyManuals Logo

Qu-Bit Electronix Chord v2 User Manual

Qu-Bit Electronix Chord v2
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
SD Card Information
chord_config.txt
A number of additional settings can be configured by editing the config.txt file on your SD
card.
Here are the available options.
QUANTIZE_AUTOHARM
LONGFORM_USERBANK
LFO_MODE
LEAD_OFFSET
QUANTIZE_AUTOHARM
When enabled, this quantizes the V/Oct and Lead inputs to the appropriate scales when
Harm is enabled.
When disabled auto-harm modes are not quantized, and the modal interchange chords are
included.
This is similar to the V1 Chord.
Default Value: 1
LONGFORM_USERBANK
When enabled a single-file custom bank of waveforms will be a single bank of 64 waveforms
instead of 8 banks of 8 waveforms.
Default Value: 0
LFO_MODE
When enabled, the frequency of the chord is reduced below the audible spectrum. This
allows the chord to function as four LFOs
The new frequency range is 6 octaves lower than the normal range.
With voicing all the way down the root output will range from 4 seconds to 60Hz
All other voices are related.
15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Qu-Bit Electronix Chord v2 and is the answer not in the manual?

Qu-Bit Electronix Chord v2 Specifications

General IconGeneral
BrandQu-Bit Electronix
ModelChord v2
CategoryMusic Equipment
LanguageEnglish