Quadra-Fire 820-0721 - Pedestal & Leg Kit Installation

5700 ACT Wood Stove


R

PEDESTAL MODEL
 
    

   

          

 
 

 
 
(see
pages 23-24)
PEDESTAL OR LEG KIT INSTALLATION
LEG MODEL
      

 
           

    

     
See Figure 16A


 

 
 
 
 
(see
pages 23-24).
)FINSTALLINGLEGSREMOVE
THESESCREWSTOATTACH
LEGBRACKETSTOBOTTOM
OFSTOVE


CAUTION! DO NOT TILT THE UNIT ON THE
CAST IRON LEGS. Lift the unit upright and
place it into position on the oor protector.
FIGURE 16A
FIGURE 16B
WARNING: DO NOT OPERATE STOVE BEFORE FULLY ASSEMBLING ALL
COMPONENTS. BURNING YOUR STOVE WITHOUT A PEDESTAL OR LEG
KIT ATTACHED WILL VOID YOUR WARRANTY AND COULD PRESENT A
SAFETY HAZARD.