Setting the Cutting Heights
Operating Instructions & Tips
IMPORTANT! Set the cutting height only when the motor is switched o and the power cable has been
disconnected.
• Turn the mower on its side.
• Pull the spring loaded axle forward or backward.
• Select a slot and insert the wheel axle.
Ensure you use the same height setting for all 4 wheels.
A higher cut height should generally be selected for the rst cut of the season.
Before you begin to mow, check to ensure that the blade is not blunt and that none of the fasteners are
damaged. To prevent any imbalance, replace blunt and/or damaged blades. To carry out this check, rst
switch o the motor and pull out the power plug.
Position Cutting height
1 20 mm
2 40 mm
3 60 mm
9
1
2
3
To Next Page
Loading...
