Qualcast M2E1232M - Carbon Brushes; Maintenance and Storage

20
Customer Helpline 08456 400 800
Blade Maintenance (continued)
Carbon Brushes
Maintenance and Storage
Maintenance
If the blade is blunt, it can be sharpened in a specialised workshop. If the blade is damaged or showing
signs of imbalance, it must be replaced.
Carry out the following steps to change the blade:
• Turn the mower over and rest it carefully on its side
20
.
• Use sturdy gloves and hold the blade rmly. Turn the blade bolt
18
anticlockwise to remove the blade
19
.
• Install the new blade in the reverse order. Ensure that the blade is positioned correctly and the screw
tightened rmly. The blade’s wings should be angled upwards (towards the mower).
• Tighten the fastening bolt. The tightening torque should be approx. 25 Nm.
IMPORTANT! Always wear work gloves when engaging in any maintenance work.
Only replace the blade with a genuine replacement blade as this will ensure top performance and safety
under all conditions.
In case of excessive sparking, have the carbon brushes checked only by a qualied electrician. Important!
Carbon brushes should only be replaced by a qualied electrician.
• There are no parts inside the mower which require additional maintenance.
• Store in a dry place, out of reach of children.