Cleaning & maintenance
Always disconnect the mains power plug before starting any cleaning work.
Cleaning
► Keep all safety devices, air vents and the motor housing free of dirt and
dust as far as possible. Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
► We recommend that you clean the device immediately each time you have
finished using it.
► Clean the equipment regularly with a moist cloth and some soft soap. Do
not use cleaning agents or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep into the device.
Replacing the blade.
H
Wear sturdy gloves!
If the blade is blunt, it can be sharpened by a specialist workshop. If the
blade is damaged or showing signs of imbalance, it must be replaced.
- Turn the mower over and rest it carefully on its side (19).
- Use sturdy gloves and hold the blade firmly. Turn the blade bolt (17)
anticlockwise to remove the blade (18).
- Install the new blade in the reverse order. Ensure that the blade is
positioned correctly and the screw tightened firmly. The blade’s wings
should be angled upwards (towards the mower).
- Tighten the fastening bolt. The tightening torque should be approx. 25 Nm.
Important.
Only replace the blade with a genuine replacement blade, as this will ensure
top performance and safety under all conditions.
Carry out the following steps to change the blade:
Carbon brushes
► In case of excessive sparking, have the carbon brushes checked only by a
qualified electrician. Important! Carbon brushes should only be replaced by
by a qualified electrician.
To Next Page
Loading...
