- MOVE DATA FROM USB TO
Q10
- MOVE DATA FROM Q10 TO
USB
- The Q10 has been fitted with a USB port, with which users can copy the grinder's configuration data to a USB
memory stick and then upload this data onto other grinders. We can also change either of the two main images
which appear on the screen.
8.3.10 – USB / CONFIGURATION / SCREENSAVER
- If we try to perform any of the described
operation and the USB memory stick is
not detected, the following screen will
appear.
For example: Copy configuration data from a USB memory stick to the Grinder.
- 1. Select the operation to be performed (fig.1). In this example, we will copy the configuration data which we
have obtained from another grinder and which has been copied onto a USB memory stick, and will be then
copied onto our grinder.
- 2. Confirm the operation (fig. 2)
- 3. Lastly, we will view a screen confirming the operation (fig.3)