3. Align the gold triangle on the CPU with the similar marking on the socket (see
Figure below). If the processor does not drop completely into the socket, turn the
socket actuator to the open position until the processor drops completely in.
Note: You should not have to press down on the processor. If the processor does not
drop completely into the socket, turn the actuator until the processor drops completely in.
Figure 6 CPU alignment in Micro-FCPGA Socket (Socket P)
4. While gently holding the processor down with your finger, secure the processor
in the socket with a screwdriver by turning the socket actuator to the closed
position:
Figure 7 Secure the processor in the socket
Removing the CPU:
To remove the CPU, reverse the installation steps.
1. Before removing the CPU, turn off the system power and wait for about 20
minutes until the heat radiation plate of the cooling fan and the CPU cools
To Next Page
Loading...
