Quantum CHECK POINT SPARK 1800 Series User Manual

Configuring VPN
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 26
To configure local users:
For new users:
1. Go to VPN > Remote Access Users.
2. Click Add to add local users.
3. Make sure that the Remote Access permissions checkbox is selected.
For more information, see "Configuring Remote Access Users" on page220 .
For existing users:
1. Go to VPN > Remote Access Users.
2. Click Edit to make sure that the Remote Access permissions checkbox is selected.
For more information, see "Configuring Remote Access Users" on page220 .
To configure RADIUS users:
1. Go to VPN > Authentication Servers.
2. Click Configure to add a RADIUS server. See "Configuring Remote Access Authentication Servers"
on page226 .
3. Click permissions for RADIUS users to set access permissions.
To configure AD users:
1. Go to VPN > Authentication Servers and click New to add an AD domain. See "Configuring Remote
Access Authentication Servers" on page226 .
2. Click permissions for Active Directory users to set access permissions.
L2TP VPN Client configuration
For L2TP VPN Client configuration, click L2TP Pre-shared key to enter the key after you enable the L2TP
VPN client method.
Advanced Options
For more information on advanced Remote Access options, for example Office Mode network, see
"Configuring Advanced Remote Access Options" on page229 .
Monitoring
To make sure Remote Access is working:
Use the configured client to connect to an internal resource from a remote host.

Quantum CHECK POINT SPARK 1800 Series Specifications

General

Brand	Quantum
Model	CHECK POINT SPARK 1800 Series
Category	Network Hardware
Language	English