Quantum CHECK POINT SPARK 1800 Series User Manual

Managing the Device
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 69
n
IP address
n
Packet Loss
n
Failures
n
Avg. Latency
n
Min Latency
n
Max Latency
n
Jitter
Probing provides information about the quality of an internet connection and what action to take if there is no
connectivity. You can configure separate probing settings for each internet connection.
To configure probing for an internet connection (pings):
1. In the Internet Connectivity page, select a connection and click Connection Monitoring.
The Edit Internet Connection window opens.
2. In the Connection Monitoring tab, select Monitor connection state by sending probe packets to
one or more servers on the Internet.
Select this option to use more methods and servers to detect connectivity loss.
3. For Connection probing method, select ping addresses.
4. Under Advanced Probing Settings, use the default values or enter new ones for:
n
Recovery time (in seconds)
n
Max latency allowed (milliseconds)
n
Probing frequency (seconds)
n
Window size (pings)
n
Failover pings (percent failures)
5. Click Apply.
To monitor a connection by DNS probe:
1. In the Connection Monitoring tab, select Monitor connection state by sending probe packets to
one of more servers on the Internet.
2. For Connection probing method, select DNS probe.
3. Click Apply.
For Cellular connections (internal LTE modem) only: Click the Monitor cellular modem link to see this
information in the Cellular Modem Monitoring window:
n
Cellular radio
n
Cellular modem
n
Operator
n
SIM cards - Which SIMis active, primary or disabled.

Quantum CHECK POINT SPARK 1800 Series Specifications

General

Brand	Quantum
Model	CHECK POINT SPARK 1800 Series
Category	Network Hardware
Language	English