Quantum CHECK POINT SPARK 1800 Series User Manual

Configuring MAC Filtering
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 97
To disable 802.1x authentication on an interface:
1. Go to Device > Local Network.
Select the LAN interface and click Edit.
2. The Edit window opens in the Configuration tab.
3. Click the Advanced tab.
4. Clear Activate 802.1x authentication.
5. Click Apply.
To configure logging for MAC filtering and 802.1x authentication:
1. Go to Device > Advanced Settings.
2. Set the value of the MAC Filtering settings - Log blocked MAC addresses attribute to
n
Enabled - To enable logging
n
Disabled - To disable logging.
Note - This attribute is available only in Locally Managed mode. In Centrally Managed mode,
configure logging with CLI.
3. Optional -
n
To reduce the number of logs, specify the value of the MAC Filtering settings - Log
suspension attribute in seconds.
n
To show all logs, set the value to "0".
Note - Traffic dropped in the WiFi driver is not logged.

Quantum CHECK POINT SPARK 1800 Series Specifications

General

Brand	Quantum
Model	CHECK POINT SPARK 1800 Series
Category	Network Hardware
Language	English