Scalar i6000 Installation Guide Super Doc 17
Figure 4 Catch Tray
1 Place the catch tray on the floor of the library over the junction between modules, with the catch tray
screw holes over the holes in the bottom rack supports.
2 Screw B screws and T-nuts should be pre-assembled. If they are not, install a T-nut on each screw in
the Screw B bag. Make sure the wider end of the T-nut faces toward the screw head.
M4X6
screw
M4 T-nut
Screw B
To Next Page
Loading...
