SELECT WANTED PROGRAM
1. Press CH + button to enter next channel.
2. Press CH - button to enter previous channel.
3. Press numeric buttons on the remote control directly to select wanted program.
Example : Track 9, press ＂9＂, three seconds later it will turn to track 9 automatically, or
press ENTER button to confirm directly.
Track 12, press ＂1＂ and ＂2＂, three seconds later it will turn to track 12 automatically, or
press ENTER button to confirm directly.
NOTE : In ATSC mode, one frequency dot may have more than one channel. For example,
track 15-3, press ＂1＂ and ＂5＂, then press ＂10+＂ and ＂3＂, three seconds later it
will turn to track 15-3 automatically, or press ENTER button to confirm directly.
VOLUME CONTROL
1. Press the VOL+ or VOL- to adjust the level of currently volume.
2.The level of VOLUME can be adjust from 0-20.
MUTE CONTROL
- Press the Mute button to mute the sound, press it again to switch ON the sound.
NOTE: When the unit is in Mute mode, pressing VOL+ button will switch ON the sound and
turn it up, pressing VOL- button will switch ON the sound and turn down the sound.
CC
It is used to set the caption mode.
-Keep pressing CC button to select different mode as desired.
-Option: On/Off.
INFO (INFORMATION)
It is used to display current program information.
-Press INFO button, the screen will display as below:
EPG (Electronic program guide)
When viewing a digital channel, press the EPG button to access
the program guide supplied by the signal provider (not available
in all areas).
Press the LEFT/RIGHT button to access previous/next page in
Electronic Program Guide.
To Next Page
Loading...