QK-A024/26 Manual
V 3.0 10 of 16 2020
The USB connection status can always be checked with a terminal monitor application like Putty or
HyperTerminal. Ensure that the COM Port is set at 38400bps, 8, N and 1 as shown below using
HyperTerminal on Windows as an example.
To use a terminal monitor application, first connect A024/26 to the computer, follow the instructions to
install the driver if required. After the driver is installed, run the Device Manager and check the COM
(Port) number.
HyperTerminal example. Run HyperTerminal, set COM Port settings to 38400bps (if using the default
A024/26 settings), 8, N and 1.
Figure 7: HyperTerminal settings
If all the above is set up correctly, similar AIS messages to the examples below should be shown.
Figure 8: Display on HyperTerminal
To Next Page
Loading...
