EN.
32
BICOM432-40-WM1 (IR) RELAY
BICOM432-40-WM1 is a bistable switch with modbus communication over IR connection.
Bistable switch is a switching device with two stable states for switching on and off all kinds of
electrical loads. When the switch is not electrically, manually or over a IR communication path,
remains stable in its operating position and will change its operating position on initiation or
actuation. initiated Switch is controllable over a IR communication interface always in a slave
communication position. BICOM432-40-WM1 has built-in electro-mechanical check of the
position status. BICOM432-40-WM1 is available as standalone unit, being also powered from
own power source over an internal power supply. By default, endpoint 3, which corresponds to
this relay, is hidden and can be enabled by changing the value of the configuration parameter
100.
IKA232-20/230VIKA232-20 is a bistable switch, which can be controlled, in contrast to the IR
relay, using a digital output (on the Smart meter). A bistable switch is a switching device with
two stable states for switching on and off all kinds of electrical loads. It can be used for remote
control of various AC devices (fast switching of motors, electric heating, lights and lightning, all
kinds of electrical and electronic equipment, which can be found in residential, hospitals,
hotels, and business premises). IKA232-20/230V is available as standalone unit, being also
powered from own power source over an internal power supply. By default, endpoint 2, which
corresponds to this relay, is hidden and can be enabled by changing the value of the
configuration parameter 100.
Both relays can be controlled using the supported actuation commands: BASIC_SET,
SWITCH_BINARY_SET.
To Next Page
Loading...
Need help?
General