EN.
19
7. Installation
Before installing the device, please read the following carefully and follow the instructions
exactly:
ⓘ Danger of electrocution!
Installation of this device requires a great degree of skill and may be performed only by a
licensed and qualified electrician. Please keep in mind that even when the device is turned off,
voltage may still be present in the device’s terminals.
ⓘ Note!
Do not connect the module to loads exceeding recommended values. Connect the module only
in accordance to the below diagrams. Improper connections may be dangerous.
Electrical installation must be protected by over current protection fuse with rated current up
to 63A, it must be used according to wiring diagram to achieve appropriate overload
protection of the module.
ⓘ Note!
The DSK code is used to include the device into the Z-Wave network. Once the device will be
mounted, access to the DSK code label may be difficult, so we suggest rewriting the DSK code
or scanning the QR code from the device label, before installing the device in electric box.
To Next Page
Loading...
Need help?
General