EN.
48
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V2
* Command classes on endpoints are supported securely only if the device is added to a Z-Wave
network as secure.
NOTE:
Endpoints are shown/hidden by Parameter No. 100
The device will be turned ON or OFF after receiving the BASIC_SET command.
To be turned ON: [Command Class Basic, Basic Set, Basic Value = 0x01~0x63; FF]
To be turned OFF: [Command Class Basic, Basic Set, Basic Value = 0x00]
BASIC SET/GET on root device is mapped to basic set/get of both endpoints.
COMMAND_CLASS_METER
Default values:
o Rate Type = 1 (Import)
Scale = 0 (kWh)
This device can be included and operated in any Z-Wave network with other Z-Wave certified
devices from any other manufacturers. All constantly powered nodes in the same network will
act as repeaters regardless of the vendor in order to increase reliability of the network.
To Next Page
Loading...
Need help?
General