LTE Standard Module Series
EC200U&EG915U_Series_PPP_Application_Note 16 / 28
6 PPP Dial-up Operations
This chapter introduces how to establish PPP dial-up in Windows 10. For detailed operations in Linux
operating system, see document [3].
6.1. Preparation
It is necessary to finish the following steps before establishing a PPP dial-up connection in Windows.
1. Connect the module to PC and enter the PIN code if the (U)SIM card PIN is locked.
2. Make sure the (U)SIM card can successfully register on GPRS network.
6.2. PPP Dial-up in Windows 10
6.2.1. Modem Configuration
6.2.1.1. Add a New Modem
If the Standard 19200 bps Modem is not installed, you need to add a new standard modem to the
modem section of the control panel.
To Next Page
Loading...
Need help?
General
