Wi-Fi&Bluetooth Module Series
FC80A_Hardware_Design 49 / 43
2.8 Label and compliance information
Grantees are responsible for the continued compliance of their modules to the FCC rules. This
includes advising host product manufacturers that they need to provide a physical or e-label
stating “Contains FCC ID” with their finished product. See Guidelines for Labeling and User
Information for RF Devices – KDB Publication 784748.
Explanation:The host system using this module, should have label in a visible area
indicated the following texts: “Contains FCC ID: XMR2022FC80A”
2.9 Information on test modes and additional testing requirements
Additional guidance for testing host products is given in KDB Publication 996369 D04 Module
Integration Guide. Test modes should take into consideration different operational conditions for
a stand-alone modular transmitter in a host, as well as for multiple simultaneously transmitting
modules or other transmitters in a host product. The grantee should provide information on how
to configure test modes for host product evaluation for different operational conditions for a
stand-alone modular transmitter in a host, versus with multiple, simultaneously transmitting
modules or other transmitters in a host. Grantees can increase the utility of their modular
transmitters by providing special means, modes, or instructions that simulates or characterizes a
connection by enabling a transmitter. This can greatly simplify a host manufacturer’s
determination that a module as installed in a host complies with FCC requirements.
Explanation: Consider multi-transmission mode in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
The grantee should include a statement that the modular transmitter is only FCC authorized for
the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host not
covered by the modular transmitter grant of certification. If the grantee markets their product as
being Part 15 Subpart B compliant (when it also contains unintentional-radiator digital circuity),
then the grantee shall provide a notice stating that the final host product still requires Part 15
Subpart B compliance testing with the modular transmitter installed.
Explanation: The host shoule be evaluated by the FCC Subpart B.
To Next Page
Loading...
Need help?
General
