GNSS Module Series
LC86L EVB User Guide
LC86L_EVB_User_Guide 18 /22
5 PowerGPS instructions
The PowerGPS tool can be used to view the status of GPS, GLONASS, BeiDou, and Galileo satellite
reception. This chapter will mainly introduce the use of the tool
5.1. COM Port and Baud Rate Setting
Step 1: After the EVB and its accessories are properly connected, power on the EVB and start
PowerGPS (this article uses PowerGPS Trial 2.3.5 as an example), and the following main interface is
displayed:
Figure 12: PowerGPS main interface (not connected)
Step 2: At the bottom of the interface, select a correct COM port and baud rate (LC86L module
supports 9600 bps by default), click the button “Create Connection”, and then the following
interface in default layout will be shown:
To Next Page
Loading...