Sportrex2 – Q6000A Subject to change. – 02|2016 – 19
Assembly
– Align the rear wheel so that it can turn freely.
– Align the coupler so that it faces horizontally to the rear.
f Tighten the connection firmly in order to secure the rear wheel:
– Quick-release axle: Tighten the cap nut until you can close the clamp with a certain amount
of pressure.
– Full axle: Tighten the nut with a spanner.
Tip!
The coupler can be permanently mounted on the bicycle. Additionally available
couplers enable you to use the Sportrex2 on different bicycles, see “Accessories” on
page 12.
The supplied universal coupler is suitable for mounting on most rear-wheel versions. If
it does not fit your bicycle, you can find suitable special couplers and conversion sets
on the Weber Technik GmbH website: www.weber-products.de
To Next Page
Loading...