Sportrex2 – Q6000A Subject to change. – 02|2016 – 21
Setting the mode
You can use the Sportrex2 in one of the following modes:
Trailer mode: Carrying children in the Sportrex2 when cycling
Buggy mode: Using the Sportrex2 like a buggy
Walker mode: Carrying children in the Sportrex2 when jogging or walking
The table below shows the main settings that you must make for particular components for the
respective mode:
Component
Status of the components in mode
Trailer Buggy Walker
Buggy wheel
must be completely
removed
fitted
(freely rotating)
fitted
(fixed)
Tow bar
unfolded
(pay attention to tow
bar load!)
folded in folded in
Pennant must be mounted recommended recommended
Push handle
maximum height
(107 cm)
comfortable height comfortable height
Hand strap on the push
handle
–
wrapped around a
wrist
wrapped around a
wrist
5-point safety harness must be fastened must be fastened must be fastened
Bicycle
the correct coupler
must be installed
– –
Optional accessories
(see “Accessories” on
page 12)
Rear light
(mandatory in poor
visibility or darkness)
–
Jogger air wheel with
hand brake
Danger!
Before every journey, make sure that necessary adjustments have been made for the
particular mode. For details of this, see the instructions in the following sections.
Adjusting the buggy wheel
You must make the following settings, depending on the mode.
Removing the buggy wheel (Trailer mode)
The buggy wheel must not be fitted in Trailer mode, because in certain riding situations it can
make contact and cause serious accidents.
f Undo the quick-release clamp with which the wheel suspension is secured on the cabin frame.
f Lift the cabin slightly at the front and completely remove the buggy wheel.
Tip!
Carry the buggy wheel e.g. in the storage space in order to allow you to use the
Sportrex2 flexibly at your destination. Instructions for re-mounting it can be found in
the chapter “Installing the buggy wheel” on page 17.
Utilisation
To Next Page
Loading...