Minimum noise levels are either at the bottom of the range or are at the
noise floor of the instrument. For readings which do not have a lower threshold
the accumulated noise will be at these levels.
Crest factor is an almost meaningless term for instruments with crest factors
in excess of 30 dB. The MICRO-15 is capable of measuring pulses as short as 1
millisecond, with a peak amplitude of 143 dB and a background level of 80 dB.
This is a pulse range of 63 dB. The crest factor would depend on how often this
pulse occurred but could be greater than 60 dB.
ACCESSORIES
Model WS-5 Windscreen
Refer to page 18 for instructions on using the windscreen with the MICRO-
15 microphone.
58-863 Microphone Boom
Refer to page 17.
Tripod
Quest supplies two tripod models for use with the MICRO-15 as an area
monitor.
Printers
The MICRO-15 can be used with a serial, 600 baud printer.
Service Policy
The Quest product you have purchased is one of the finest acoustic instru-
ments available. It is backed by our full one year warranty which seeks complete
customer satisfaction. This is your assurance that you can expect prompt
courteous service for your equipment from the entire Quest service organization.
Should your Quest equipment need to be returned for repair or recalibration,
please contact the Service Department at (800)245-0779 (USA) or Fax (262)567-
4047 for a Return Authorization Number. The RA number is valid for 30 days,
and must be shown on the shipping label and purchase order/cover letter. If you
are unable to return instruments in that time call for a new RA number. Send it
prepaid and properly packed in the original shipping carton directly to Quest
Technologies, 1060 Corporate Center Drive, Oconomowoc, WI 53066 U.S.A.
Repair or replacement work done under warranty will be performed free of
charge, and the instrument will be returned to you prepaid. Your copy or a
photocopy of the Quest Registration Card will serve as proof of warranty should
the factory require this information.
If for any reason you should find it necessary to contact the factory regarding
service or shipping damage, please direct your calls or letters to the attention of
the Service Manager, Quest Technologies, (262) 567-9157 or (800) 245-0779.
Office hours are from 7 AM to 6 PM (Central Standard Time) Monday through
Friday.
For service or recalibration outside the U.S.A., please contact your local
Quest Dealer or fax Quest U.S.A. at 1-262-567-4047.
To Previous Page
Loading...
Need help?
General
