Quick MILL Vetrano 2B - PID Controller Settings; Temperature Display; Setting Coffee Boiler Temp; Setting Steam Boiler Temp

For support email service@chriscoee.com or call 518.452.5995.
PID CONTROLLER (04)
The PID controller’s display (04) will cycle back-and-forth to show the current temperature of each
boiler. The position of the decimal point (2+3) indicates which boiler the temperature is being
shown for at that time i.e. 25.5 is displaying the steam boiler temperature (by default) and 200.
(by default) is displaying the coee boiler temperature.
SETTING TEMPERATURE OF THE COFFEE BOILER
01. Turn on your Vetrano 2B Evo and press both the left and right PID buttons simultaneously until
the display reads T1, then release both the left and right PID buttons.
02. Press the right button of the PID to display the current temperature setting of the coee boil-
er. While the current temperature (set by default to 200) is being displayed press either the left
(down) or right (up) PID buttons to change the temperature of your coee boiler.
03. After a couple of seconds the display will revert back to T1 and your new temperature has
been saved.
SETTING TEMPERATURE OF THE STEAM BOILER
01. Turn on your Vetrano 2B Evo and press both the left and right PID buttons simultaneously until
the display reads T1, then release both the left and right PID buttons.
02. Press the right button of the PID until T2 is displayed. Press the right (up) PID button, the
current steam boiler temperature (set by default to 255) is displayed. While the current tempera-
ture is being displayed press either the left (down) or right (up) PID buttons to change the tempera-
ture of your steam
boiler.
03. After a couple of seconds the display will revert back to T2 and your new temperature has
been saved.