Quick BTQ125 - Page 26

EN
BTQ110-125 INSTALLATION AND USE MANUAL - IT EN - REV004A
26
BTQ110/1256 - Warnings
F
NOTE: the bow thruster must be installed with the propeller on the
right-hand side of the gearleg (see gure).
In case the bow thruster needs to be installed on the opposite position,
the connection of the two wires (blue and grey) to the control cable on the
reversing contactor unit must be inverted.
RH
• This thruster is not designed for continuous use. It is equipped with protections which limit its operation at a maxi-
mum time span, as reported on the controls’ manual.
It is strongly forbidden to bypass or modify such protections in order to increase the operating time span, lest voiding
the warranty and thus lifting any responsibility from Quick SPA.
• Make sure no swimmers or oating objects are in the vicinity before switching on the thruster.
• There must not be ammable materials in the peak or in the area where the Thruster motor is.
• Do not operate the bow thruster out of the water for more than 10 seconds.
• During mooring, it is recommended not to leave in the water any free line, which may be sucked in by the propel-
lers, thus leading them to break.
6.0 - Warnings
Start-up
Start-up happens following activation of a TCD panel.
To use the thruster refer to the manual of the TCD control.
7 - Usage BTQ110/125