12.4 Crash testing on the SALSA, all models.
A representative SALSA & SALSA M wheelchair has
been tested in accordance with the dynamic performance
requirements specified in ISO 7176-19:2001 “Wheeled
Mobility Devices for use in Motor Vehicles” using a Q
straint 6 point strap restraint system with double straps at
the rear which conform to ISO 10542 or SAE J2249 and
was used in accordance with the WTORS manufacturer’s
instructions.
The Q straint restraint system was used for these tests.
However other restraint systems can be used as long as
they conform to ISO 10542 or SAE J2249 and are used in
accordance with the WTORS manufacturer’s instructions.
They must also be checked to make sure that they are
sufficiently specified for the weight of the wheelchair and
rider
WARNINGS!
All restraint systems must conform to ISO 10542 or •
SAE J2249.
All restraint systems must be used in accordance with •
the WTORS manufacturer’s instructions.
All restraint systems must be checked to make sure •
that they are sufficiently specified for the weight of the
wheelchair and rider
12.5 The tie down label and placement
The label shown in Fig 12.6 is used to identify the tie down
points on all chair models.
Fig. 12.7 - 12.10 show the tie down label placements on the
SALSA & SALSA M.
Fig.12.6
Fig.12.7
Fig.12.8
Fig.12.9
Fig.12.10
To Next Page
Loading...
Need help?
General
