Quicksilver 455 Cabin - Cockpit Table; Interior Cabin Filler (Optional); Back Bench Filler Seat (Optional)

Quicksilver 455CAB — System & Component Overview and Operaon
21
Interior Cabin Filler
Filler boards
Filler cushion
9. Interior Cabin Filler (oponal)
An oponal interior cabin ller is available for this boat, allowing you to convert the forward V-berth
area into a full size maress for sleeping. Simply place the ller boards in the grooved edge along the
V-berth. The boards will lock into place due to their shape. Complete the berth by placing the ller
cushions over the ller board.
Cockpit Table
Table base
Table leg
Cockpit table
10. Back Bench Filler Seat (oponal)
An oponal back bench ller seat is available to increase the seang area in the cockpit by creang a
connuous back bench at the a end of the boat. When installed, the back bench ller covers the
motorwell, however, it does not interfere with normal operaon and trimming of the engine. If you
want to trim the engine to trailer posion or use the boarding ladder, the seat will rotate forward.
Simply pull the upper bar on the seat frame forward and the seat will move out of the way.
8. Cockpit Table
On your boat, a cockpit table is available for entertaining. This table and table leg are removable and
can be stored in brackets inside the forward cabin area. To install the table, rst remove the plasc
cover located in the table base plate. Next, screw and lock the table leg into the base plate. Finally,
screw the table onto the table leg.