EasyManua.ls Logo

Quicksilver 455 Cabin - Canvas (Optional)

Quicksilver 455 Cabin
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Quicksilver 455CAB — System & Component Overview and Operaon
11. Canvas (oponal)
The oponal canvas consists of a bimini with frame along with vinyl panels which fully encloses the
cockpit.
Bimini
When not in use, the bimini can be stored in an a posion where it does not interfere with the use of
the boat. In this posion, always make sure that the bimini is secured in the canvas boot. To use the
bimini, remove the canvas boot and rotate the two bimini frames forward and secure the bimini
straps to the deck trail. DO NOT OPERATE YOUR BOAT WITHOUT THE BIMINI STRAPS ATTACHED TO
THE DECK.
Bimini with Enclosure
In addion to the bimini, clear vinyl panels can be installed to enclose the cockpit. Each panel aaches
to the bimini with a zipper and snaps or studs are used to aach to the deck.
NEVER TRAILER THE CANVAS BIMINI OR BIMINI WITH
ENCLOSURE IN THE UPRIGHT POSITION.
The bimini canvas must be secured in the canvas boot with
the rails in the stored posion before trailering.
Back Bench Filler Seat rotated forward
Back Bench Filler Seat
Back bench ller seat
Upper handle bar
Back Bench Filler Seat in “lounge” posion
Before trimming the engine to trailer mode, make sure that
the back bench ller is rotated forward. Failure to do so
could cause damage to the engine and bench seat.
NEVER OPERATE THE VESSEL WITH THE CANVAS
ENCLOSURE UNLESS THERE IS VENTILATION THROUGHOUT
THE BOAT. The forward and a canvas panels must be
removed to allow air ow through the boat so Carbon
Monoxide cannot accumulate.

Related product manuals