Quicksilver 555 Cabin - Back Bench Filler Seat (Optional); Sun Lounge (Optional)

Quicksilver 555CAB — System & Component Overview and Operaon
25
Back Bench Filler Seat rotated forward
13. Back Bench Filler Seat (oponal)
An oponal back bench ller seat is available to increase the seang area in the cockpit by creang a
connuous back bench at the a end of the boat. When installed, the back bench ller covers the
motorwell, however, it does not interfere with normal operaon and trimming of the engine. If you
want to trim the engine to trailer posion or use the boarding ladder, the seat will rotate forward.
Simply pull the upper bar on the seat frame forward and the seat will move out of the way.
Back Bench Filler Seat
Back bench ller seat
Upper handle bar
Back Bench Filler Seat in “lounge” posion
Before trimming the engine to trailer mode, make sure that
the back bench ller is rotated forward. Failure to do so
could cause damage to the engine and bench seat.
Interior Table
Table base
Table leg
Interior table
14. Sun Lounge (oponal)
As an opon, your boat may be equipped with a sun lounge. The sun lounge consists of a single
berglass panel and a cushion. To use the lounge, remove the single cushion from the back bench
seat. Next, rotate the sun lounge panel forward 180 degrees. Finally, install the sun lounge cushions.