Quicksilver Activ 755 Open - Macerator Operation

Quicksilver 755OP — System & Component Overview and Operaon
21
Macerator
The macerator gives the boat operator the means of discharging the holding tank directly
overboard through a seacock in the boom of the hull. The macerator controls are located next to
the main baery panel located in the center a storage box. Since direct overboard discharge is
prohibited in many areas, the macerator seacock is normally closed.
To Operate the Macerator:
1. Make sure the macerator seacock is in the open posion.
2. Press and hold the macerator switch located on the main baery panel. The macerator
switch is a momentary switch, which means that it needs to be held in the “ON” posion
during operaon.
3. When the tank is empty, release the macerator switch.
4. Return the macerator seacock to the closed posion.
Toilet Operaon
Rotate the interior step so that the toilet
will not hit it when sliding into the
operaonal posion.
Using the notch in the board, slide the
toilet out from the storage posion.
Avoid inadvertent discharge of the black water system.
Always keep the macerator seacock closed when not in use.
Macerator Switch Locaon
Macerator switch