Quicksilver Activ 755 Open User Manual

Quicksilver 755OP — System & Component Overview and Operaon
39
To complete the sun lounge, you must install the ller panels located on the forward console seat and
the port and starboard cockpit walls. Rotate the plasc panel located on the forward console unl it
rests on the a edge of the table. Now, unclip the plasc panels located on port and starboard cockpit
wall and rotate the panels down unl it rests on the edge of the console and bow seats. Finally, install
the cushions.
Along with the table, the cushions store in the cabin when not in use.
Sun Lounge
Sun lounge w/ table lowered
Sun lounge with llers boards installed Sun lounge with cushions installed
Bow cockpit table
Table support leg
Console ller board
Port ller board
Starboard ller board
Console ller pad
Port ller pad
Starboard ller pad
Bow table ller pad
Forward console cushion
Port bow seat cushion
Starboard bow seat cushion
Center bow seat cushion
24. Canvas (oponal)
As an opon, a bimini with a frame, a bimini with vinyl panels that fully encloses the cockpit, and a
forward sun awning can be installed on your boat.
Bimini
When not in use, the bimini can be stored in an a posion where it does not interfere with the use of
the boat. In this posion, always make sure that the bimini is secured in the canvas boot. To use the

Quicksilver Activ 755 Open Specifications

General

Brand	Quicksilver
Model	Activ 755 Open
Category	Boat
Language	English