Section VI - Servicing
Quincy Compressor-QSI
®
83
• Safety
• Water Removal
• Air/Fluid Separator Element
• Fluid Scavenging System
• Air Filter
• Control Line Air Filter
• Shaft Seal
• Air and Fluid Tubing
• O-ring Fittings
Safety
NOTICE!
Maintenance should be performed by trained and
qualied technicians only.
Safety procedures while servicing the compressor are
important to both the service personnel and to those who
Listed below are some, but not all, procedures that should
be followed:
•
Temperatures may exceed 180°F when the compres-
•
•
•
• Safety solvents are available and should be used in
CAUTION!
Unusual noise or vibration indicates a problem.
Do not operate the compressor until the source
has been identied and corrected.
Water Removal
Water vapor may condense in the reservoir and must be
-
-
ing hot and humid conditions, water should be drained
To drain water from the reservoir, turn the compressor
is no pressure in the reservoir before opening the drain
Air/Fluid Separator Element
The separator element is a one piece construction that co-
into droplets that fall to the bottom of the separator ele-
ment to be picked up by a scavenging tube and returned
-
hole punctured through the element will result in a high
To Next Page
Loading...
Need help?
General
