Section VI - Servicing
86 Quincy Compressor-QSI
®
Shaft Seal
Compressor shaft seals are wear items that may eventu-
understanding of the installation procedure are required
distributor for complete illustrated instructions (avail-
able as a Service Alert) at the time you order the seal and
If your distributor does not have a copy of these instruc-
tions, they can be ordered from Quincy Compressor at no
complaint of shaft seal leakage requires that the scavenge
system be inspected for proper operation prior to the
of the following:
•
• Inspect the performance of the scavenge line check
-
-
• Remove the coupling guards and coupling halves
• Remove the drive coupling hub and key from the
•
• Remove the four bolts securing the seal adapter to
• Insert two of the seal adapter retaining bolts into the
seal adapter jack holes and turn clockwise (pushing
• After the seal adapter outer o-ring has cleared the
• Disassemble the seal adapter as follows:
end of the shaft and allow the jaws of the tool
Tighten the outer shell of the tool down over
screw clockwise in against the end of the com-
CAUTION!
Do Not use an impact wrench with this tool.
To Next Page
Loading...
Need help?
General
