Section VII - Compressor Fluids
90 Quincy Compressor-QSI
®
Lubrication
-
sages to ensure positive lubrication of the bearings and
-
ginning stage of the compression cycle to seal clearances
-
Consult the Quincy Service Department before changing
Fluid Level
Fluid level is monitored by a sightglass or a dial gauge
Figure 1-1. Fluid Level Sight Gauges
-
surized air venting through the hole, immediately screw
CAUTION!
Hot uid under pressure could cause death or
serious injury. Do not remove the uid ll plug
and attempt to add uid to the reservoir while the
compressor is in operation or when the system is
under pressure. Be sure that the compressor’s red
mushroom stop button is pushed in and locked
and that the main power disconnect switch is in
the o position and locked out to assure that the
compressor will not start automatically.
To Next Page
Loading...
Need help?
General
