Quooker PRO3-VAQ - E Tank Descaling: Important Notes and Support

COLD
20 Place the hose with the solenoid valve (black cube) over the middle of the insulation.
- Plug the cable connectors into the cover.
21 Push the hose connector partly through the hole in the cover. Place the cover back in the
notch. Push it further into place without pinching the cables. Secure the cap screws.
- In case of a PRO3-VAQ E tank, connect the hose from the inlet combination using the large red
fibre washer. In case of a COMBI E tank, connect the two hoses from the mixing valve.
Connect the tap hose to the tank with the small washer. Connect the LED cable. Plug the tank
back in. Switch the power on but not the tank yet.
22 Open the boiling-water tap, then the grey stop valve on the inlet combination and flush the
tank through for a couple of minutes until the water is clear.
- Check for leaks. Switch the tank on with the Q-shaped button.
20 21
22
Please note
Atrstthewatermaybeblack.Thisisdue
tocarbonfromtheactivatedcarbonlter
and is perfectly harmless.
After switching on the tank, the light
should be on both the tap and tank.
The tank will be fully heated and ready for
use in around 10 - 20 minutes. After it has
heatedup,thetaplightwillgooandthe
tank light will change to a fading in and
out (heartbeat light).
From time to time, unscrew the tap nozzle
and descale the aerator in a vinegar-
water solution.
For any further questions, do not hesitate
to contact our service department on
0207 923 33 55 (option 3 for service) or
email us at: service@quooker.co.uk.