7
2. Complete the antenna settings of this satellite.
3. Highlight the Start Search and select Blind Search then press the OK button to confirm.
D: TP Search
1. Highlight the Satellite and press the OK button to enter satellite list.
2. Complete the antenna setting of this satellite.
3. Highlight the Transponder and press the OK button to enter TP list.
4. Highlight the Start Search and select Transponder then press the OK button to confirm.
E: Multi TP Search
1. Highlight the Satellite and press the OK button to enter satellite list.
2. Complete the antenna setting of this satellite.
3. Highlight the Start Search and select TP Search then press the OK button to confirm.
4. Highlight the transponders in the TP list press the OK to mark them.
5. Press Exit will start searching programs of the transponders you have marked.
4.1.4 Anten na Settings for Motor
Menu-> INTALLATION ->Antenna Setti ngs- >Motor
1. Motor Mode:
Select DiSEqC 1.2 or USALS using the
button.
DiSEqC 1.2: General motor antenna using DiSEqC 1.2.
USALS: Motor antenna using USALS.
button, the dish will be motorized to East/West
continuously; it will stop until it find the best signal
button, the dish will be motorized to East/West
step by step, until you find the best signal showed on the
signal bar.
Fine Tuning (1)
Input digital button to set the moving step
Store Position
Save the current position you searched.
Go to Position
Press OK button to move the dish to the position that you saved.
Go to Reference
Press OK button to move the dish to 0 positions.
Set West Limit
You can set the maximum motor limit for both West to prevent damage to the antenna.
Set East Limit
You can set the maximum motor limit for both East to prevent damage to the antenna.
Disable Limit
Disable West limit and East limit.
Go to X.X
Press OK button to move the dish to the USALS Setup.
Tip: Before you use USALS, you should go to Main Menu ->INTALLATION -> USALS Setup to set you local
position firstly.
To Next Page
Loading...
