4
2 Installation
Step 1 of 5 – Preparation
Open the driver’s door as far as possible.
Remove any mats and move the driver’s seat all the way back.
Switch the ignition off, remove the key.
Ensure the footwell is properly illuminated with an inspection lamp.
Wait about 10 minutes before starting Step 2, as all current consumers must have
switched themselves off.
• For cars with “Keyless Go”: after locking the car, place the key out of signal range
(about 10 m from the car).
• If an alarm system is tted: disable the alarm before starting installation.
1
2
3
4
5
To Next Page
Loading...
